B&B Electronics 3PCIOU1 Specifikace stáhnout pdf (Strana 11)

Serial Card Setup

Document Number 3PCI-4310m Chapter 2 5

The following Serial Card Setup section applies to the following PCI cards:

• 3PCIOU1 one port optically isolated PCI serial card

• 3PCIOU2 two port optically isolated PCI serial card

• 3PCIOU4 four port optically isolated PCI serial card

• 3PCIU2 two port non-isolated PCI serial card

• 3PCIU4 four port non-isolated PCI serial card

• 3PCIU8 eight port non-isolated PCI serial card

Any deviations from the procedure for specific models are noted.

Pre-Setup Steps

Your serial card has been tested for proper operation before packaging and shipping. It

should be in perfect mechanical and electrical condition upon receipt.

ESD Precautions

To ensure a successful installation and setup it is important that you follow the standard

ESD precautions outlined below:

CAUTION:

This is an Electrostatic Sensitive Device. Use ESD precautions for

safe handling.

Before removing the card from the anti-static protective packaging:

• Discharge any static electricity buildup on your body by touching a large

grounded metal surface or the metal chassis on equipment connected to

earth ground by a 3-wire power cord. Use of a grounding wrist strap is

recommended.

• Avoid touching the gold connectors or other parts on the card except

when necessary to set the configuration DIP switches.

•

Remove AC power from the computer before inserting the card

Initial Configuration

The ports in your MIport card are normally pre-configured for RS-232 operation. To ensure

the card is configured correctly for your desired operating mode, you will have to check

and/or set the three operating mode DIP switches on the card. If you are configuring for

RS-485 Mode you also may have to set up the RTS Control parameter in the device driver.

Note: Refer to Chapter 4 for information on Setting Driver Options.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 56 57

Žádné komentáře

B&B Electronics 3PCIOU1 Specifikace Strana 11