
B&B Electronics, Inc. SPECTRE Configuration Manual
SPECTRE_Configuration_Manual_2912m
www.bb-elec.com
www.bb-europe.com
1.25. USB port configuration
Select the USB Port item in the configuration menu to bring up the USB
configuration page. A USB to RS-232 converter can be used to send data out of the
serial port from the Ethernet network.
Applied communication speed.
Control parity bit
none
even
odd
Inter-character Timeout (ms). If no characters are received within this
amount of time, any buffered characters will be sent out of the USB port.
Communication protocol:
TCP - communication using a linked protocol TCP
UDP - communication using a unlinked protocol UDP
Mode of connection:
TCP server - The router will listen to incoming requests regarding
the TCP connection.
TCP client - The router will connect to a TCP server
on the specified IP address and TCP port.
In mode TCP client it is necessary to enter the Server address and final
TCP port.
In both modes of connection it is necessary to specify the TCP port on
which the router will communicate TCP connections.
Table 56: USB port configuration 1
If the Check TCP connection is selected, the router will automatically send TCP
keep-alive messages to verify that the connection is still valid.
Time between sending keep-alive packets
Keep-alive Response Tiimeout
Number of attempts before connection is down
Table 57: USB PORT configuration 2
It the option Use CD as indicator of the TCP connection is selected, the router will
activate the DTR output when a TCP connection is active.
Table 58: CD signal description
Komentáře k této Příručce